Wrimco Waterproofing                                             Home | Product | Project | Technical data | Contact us

Torch on Membrane

Liquid Membrane

Protection Board

Backing Rod

Cement Adhesive

Drainage Sheet

Product Range 

Company Profile

Licensed Contractor

Membrane Protection

NATSPEC Specification

Product Application 

Roof Waterproofing

SBS Membrane

Waterproof Bathroom

Waterproof Coating

Waterproofing FAQ

Waterproofing Primer

Waterproofing Sealant

 

 

 

 

Waterproofing Drainage Cell:

AUSDRAIN 30mm Drainage Cell creates a permanent non-clogging void between the concrete slab and the soil profile that will not collapse or distort. The 30mm void enables a direct flow of water to designated outlets avoiding the risk of water build-up and penetration. The large surface and capacity void space enables superior drainage efficiency compared to the small voids created by using a gravel system. 

The lightweight nature of this product reduces weight on the structure by 98% over gravel making it the perfect choice for roof gardens and podiums. In addition, there is a 5:1 reduction in the drainage medium height allowing greater soil depth and scope for plantings.   

The AUSDRAIN cell is the strongest product available on the market with a university tested compressive strength up to 1500 kPa. This allows materials to be delivered directly by truck and machinery to spread sand and soil once a minimum of 400mm has been placed over the drainage cell/ filter fabric layer.

 

Filter fabric is placed over the drainage cell and is supplied in roll widths of 2m and 4m. The fabric, combined with a layer of washed sand, filters the water eliminating staining caused by gravel, stone and soil materials. The drainage cell also acts as a membrane protection layer, however, depending on the membrane it is recommended to use a suitable protection board between the membrane and drainage cell layer.

 

AUSDRAIN 30mm Drainage Cell is available in 356 x 356mm modules for smaller areas, 356 x 1068mm strips or 1068 x 1068mm interlocked panels for ease of installation on large area projects.    

 

AUSDRAIN 30mm Drainage Modules     

 

AUSDRAIN 30mm drainage modules are ideal for horizontal drainage in smaller landscaped areas and vertically to assist tanking in planter boxes. The modules are easily placed and cut where necessary providing a continuous drainage layer. Filter fabric is supplied separately and is easily laid over the drainage modules. Where required, the drainage modules can be interlocked to form continuous vertical sections or are simply laid adjacent to one another on flat areas. The modules are supplied in bundles of 2 sqm for easy handling. 

  

Applications

Roof Gardens

Planter Boxes

Podiums

Paving

 

AUSDRAIN 30mm Drainage Panels

 

AUSDRAIN 30mm drainage panels are supplied in 1068 x 1068 panels and have become the most efficient product for drainage cell installations available on the market. These panels have been used extensively by landscapers, waterproofers and civil contractors in jobs ranging from larger size planter boxes to rooftop podiums of up to 10,000 sqm. The panels comprise of 9 interlocked standard modules which has enabled contractors to cut installation times by up to 3 times, saving valuable time and money on larger projects.  

 

Applications

Roof Gardens

Planter Boxes

Podiums        

Civil Works

Reservoirs

Golf Courses

Race Courses

Paving Sports Fields

 

 

AUSDRAIN 30mm Drainage Strips   

 

AUSDRAIN 30mm Drainage Strips are supplied in 356 x 1068 pieces and are ideal for narrow planter boxes and landscaped areas, vertically along planter box walls, vertically against footings and foundations and as an efficient trench drainage system to replace conventional silver pipes and gravel methods.

 

The strips can be easily interlocked to form continuous lengths and can be easily wrapped with filter fabric supplied separately on-site. They provide efficient water collection and discharge through the open void spaces.

 

 

Applications

Roof Gardens

Planter Boxes

Podiums

Paving

Vertical Drainage

Trench Drainage

 
Filter Fabrics 

 

AUSDRAIN supplies a large range of geotextile fabrics and is a main supplier to the landscaping

industry. Fabrics are available in roll widths of 1.0, 2.0 and 4.0m and up to lengths of 200 lineal

metres. The most widely used fabric for landscaping applications is Geotex 401 which is a polyproylene, staple fibre, needle-punched non woven geotextile. non_woven_geotextile.pdf

 

The fibres are needled to form a stable network that retains dimensional stability relative to each other. The geotextile is resistant to ultraviolet degradation and to biological and chemical environments normally found in soils.  

   

Applications

Landscaping

Earthworks

Roadworks

Land remediation

 

Installation Instructions and Technical Data 

 

 

 

The AUSDRAIN 30mm Walldrain Panel is a rigid, high compressive strength drainage cell product that is perfect for basement and retaining wall applications. The panels are pre-wrapped with filter fabric on both sides and pre-assembled according to the required wall heights in 1068mm widths up to heights of 2.85 metres.

This makes them both easy to install as there is little cutting required and also avoids unnecessary

wastage as exact quantities can be ordered for each job.

 

AUSDRAIN 30mm Walldrain Panels creates a structural void between the wall and the back-fill protecting the waterproof membrane and providing excellentdrainage efficiency. This eliminates the need for gravel as the primary back-fuill material.

 

The result is a continuous discharge of water preventing any water contact with the wall surface and avoiding damage from hydrostatic pressure. The high compressive strength of the panels withstands heavy compaction as well as ground and structural movement.

 

Applications

Basement walls

Underground carparks

Foundation walls

Retaining walls

Bridge abutments

 

 

DORKEN Delta NP Drainage Sheeting is a high compressive drainage sheet that provides high drainage capacity through specially configured dimples. The product is perfect for most vertical applications in building, underground and civil engineering construction.
 
Download brochure: Delta NP Brochure , Delta Drain Brochure
 
The product is available in 2.0m x 20.0m rolls and has an integrated geotextile fabric to filter out suspended soil particles ensuring constant drainage through the vertical void created by the dimples.

 

Applications

Basement walls

Carparks

Cut and cover tunnels

Retaining walls

 

AUSDRAIN 30mm, 60mm & 90mm Filter Pipe 

 

Ausdrain Filter Pipe is supplied in various sizes (30mm, 60mm & 90mm) and provides an efficient and cost-effective alternative to conventional sub-soil drainage applications. The product replaces the need for both silver lines and gravel and provides a highly efficient means to absorb and discharge water.

Filter Pipe is supplied in pre-wrapped lengths with a sleeve on each end for consecutive lengths to
slot in to. It is both quick and easy to install and can be easily connected to PVC pipes or fed into stormwater collection pits. 

 
 

Applications

Basement walls

Retaining walls

Trench drainage

Foundations

Installation Instructions and Technical Data
 

 

Contractor | Backer Rod   |    Waterproof membrane    |   Drainage cell   |    Coating    | Protection Board   | Waterproof Bathroom | Waterproofing Primer   | Waterproofing Sealant | XPS Extruded Polystyrene | Phone: (02) 9660 8333  |  Fax: (02) 9692 8600  |  10 Hill Street, Leichhardt NSW 2040 Australia